AEM Tru-Boost X

Description

The Tru-BoostX Boost Controller Gauge delivers all of the features you loved about the original only now with AEMnet for data logging and a big, fat internal MAP sensor that can handle boost pressures up to 80 PSI of boost. The King is dead, long live the King!

The Tru-BoostX Boost Controller gauge delivers digital accuracy but with the simplicity of a manual boost controller. All programming is done using the faceplate buttons and no laptop is required. AEM’s specially designed Boost Control Solenoid and all necessary hardware is included.

*Program Two Boost Levels + Scramble Boost Setting* – Program two boost modes for different levels of performance (up to 80PSIg internal MAP sensor), and program a time-based scramble boost setting that is controlled using a switched input. You can also turn off the controller and use the gauge as a display.

*Change Wastegate Open Pressure* – Ideal for reducing boost spikes and improving spool up.

*Display Boost Levels in PSIg (PSI), BAR or kPa (PAS)* – See your boost in the units you prefer, and scale the 24 outer LEDs to match your peak boost levels for the perfect sweeping motion.

*Set Alarms and Display Peak Boost* – Set the 24 green outer LEDs to flash based on boost pressure so you are alerted to an overboost condition. A ground output is included for triggering an optional LED warning light. Select the “B” button to see peak boost level and clear the value using the menu.

*Overboost Protection Built In* – Protects your engine from an overboost condition by shutting the boost control solenoid off until it is reactivated by you through the buttons on the faceplate. *Integrated Error Protection* – Alerts you to a fault if the boost control solenoid is shorted or disconnected so you are never left guessing whether the Tru-BoostX is operational.

*Datalog using AEMnet CAN bus* – Outputting channels over AEMnet provides so much more than just boost pressure! Send 13 channels of data over a 2-wire connection, including boost pressure, peak boost, boost target, boost scramble duty, overboost status, wastegate crack pressure, boost control solenoid status and more.

*Tru-BoostX Gauge Features:*

* A boost display gauge and boost controller in one!

* Easy to program – no laptop required

* Boost control solenoid and all necessary hardware included

* On-board 80PSIg MAP sensor—no upgrade kit needed for high boost vehicles

* Two boost level settings and scramble boost setting

* Wastegate open pressure setting for controlling boost spikes and faster spool

* Display boost levels in PSI, BAR or kPa

* Overboost protection and programmable alarms, ground output for optional LED warning light

* Peak boost level recall

* X-Series design for the best visibility (87% larger center LED and 33% larger face design)

* X-Series dimensions make it easier to install (0.825” overall depth, 0.20” cup depth)

* AEMnet CAN bus enabled for data logging (13 channels of data over 2-wire connection)

* Standard 52mm (2-1/16”) cup

* 24 programmable green outer LEDs

* Auto dimming sensor for ideal brightness day or night

* Positive locking connectors

* Optional silver bezel with white faceplate accessory kit (30-0352-ACC)